往复荷载下含孔洞缺陷衬砌混凝土的力学性能试验研究

摘要/Abstract

摘要： 通过添加不同含量的发泡聚苯乙烯(EPS)颗粒来预制目标孔隙率以模拟混凝土的不同孔洞缺陷,制备了不同孔隙率的C25和C30两种强度等级的混凝土试件,开展单调及往复荷载下含孔洞缺陷混凝土力学性能的试验研究,分析了混凝土试件破坏形态、强度、应变、弹性模量等随孔隙率的变化规律,探讨不同孔洞缺陷对混凝土力学性能的影响。试验结果表明:单调及往复荷载下,无预制孔洞缺陷的混凝土试件均表现为脆性破坏特征。但随着孔隙率的增加,混凝土试件的强度明显降低,应力-应变曲线逐渐趋于鱼肚状分布,试件由脆性向延性破坏转变,逐渐呈现多裂缝扩展特征,特别是对于往复加载情况。两种加载方式和两种强度等级条件下,试件主要力学参数随着预制孔隙率的增加均表现出一致的变化规律。峰值应力和弹性模量随孔隙率的上升呈指数下降,而峰值应变和应变极值呈线性增大。往复荷载下试件力学性能受孔隙率的影响程度均大于单调加载情况,而且,这种影响随混凝土强度的提高而减小。在往复加载过程中,孔隙率越大,峰值应力前试件的刚度比值越大,而峰后的刚度退化也愈严重。对于相同的孔隙率,混凝土强度等级越高,峰值应力前的刚度增长率及峰后的刚度退化程度越小。

关键词: 衬砌混凝土, 孔洞缺陷, 往复荷载, 破坏特征, 应力-应变曲线, 刚度退化

Abstract: The target porosity was prefabricated by adding different content of expanded polystyrene (EPS) particles to simulate different hole defects of concrete, and concrete specimens with different porosity levels of C25 and C30 were prepared to develop the mechanical properties of concrete with hole defects under monotonic and reciprocating loading. In the experimental study, the changes in the shape, strength, strain and elastic modulus of concrete specimens with porosity were analyzed, and the influences of different hole defects on the static and dynamic properties of concrete were discussed. The test results show that under monotonic and reciprocating loading, the concrete specimens without prefabricated hole defects show brittle failure characteristics. However, with the increase of porosity, the strength of concrete specimens decreases significantly, and the stress-strain curve gradually tends to distribute in a fish-maw shape. The specimens change from brittle to ductile failure and gradually show the characteristics of multi-crack propagation, especially for reciprocating loading. Under the two loading methods and two strength levels, the main mechanical properties of the specimens show consistent changes with the increase of the precast porosity. Peak stress and elastic modulus decrease exponentially with the increase of porosity, while peak strain and extreme strain increase linearly. The influence of porosity on the mechanical properties of specimens under reciprocating loading is greater than that of monotonic loading, and this effect decreases with the increase of concrete strength. In the reciprocating loading process, the greater the porosity, the greater the stiffness ratio of the specimen before the peak stress, and the more serious the stiffness degradation after the peak. For the same porosity, the higher the concrete strength grade, the smaller the stiffness growth rate before the peak stress and the less the degree of stiffness degradation after the peak.

Key words: lining concrete, hole defect, reciprocating loading, failure characteristic, stress-strain curve, stiffness degradation

中图分类号:

TU528
U455

王顺国, 丁祖德, 汪伟伟, 张万平, 沈万虎. 往复荷载下含孔洞缺陷衬砌混凝土的力学性能试验研究[J]. 硅酸盐通报, 2022, 41(3): 833-843.

WANG Shunguo, DING Zude, WANG Weiwei, ZHANG Wanping, SHEN Wanhu. Mechanical Properties of Lining Concrete with Hole Defects under Reciprocating Loading[J]. BULLETIN OF THE CHINESE CERAMIC SOCIETY, 2022, 41(3): 833-843.

参考文献

[1] 丁祖德,资昊,计霞飞,等.考虑衬砌劣化的山岭隧道地震易损性分析[J].岩石力学与工程学报,2020,39(3):581-592.
DING Z D, ZI H, JI X F, et al. Seismic fragility analysis of mountain tunnels considering lining degradation[J]. Chinese Journal of Rock Mechanics and Engineering, 2020, 39(3): 581-592 (in Chinese).
[2] 李尧,李术才,徐磊,等.隧道衬砌病害地质雷达探测正演模拟与应用[J].岩土力学,2016,37(12):3627-3634.
LI Y, LI S C, XU L, et al. Forward simulation of ground penetrating radar and its application to detection of tunnel lining diseases[J]. Rock and Soil Mechanics, 2016, 37(12): 3627-3634 (in Chinese).
[3] MEGUID M A, DANG H K. The effect of erosion voids on existing tunnel linings[J]. Tunnelling and Underground Space Technology, 2009, 24(3): 278-286.
[4] 梁栋,黄鑫.隧道衬砌不密实的探地雷达数值模拟[J].南京工程学院学报(自然科学版),2014,12(1):48-52.
LIANG D, HUANG X. Numerical simulation of ground penetrating radar of non-compactness of tunnel lining[J]. Journal of Nanjing Institute of Technology (Natural Science Edition), 2014, 12(1): 48-52 (in Chinese).
[5] 雷坚强.公路隧道二次衬砌混凝土厚度及密实性试验研究[J].公路,2016,61(2):201-208.
LEI J Q. Experimental research on concrete depth and compactness of secondary lining in highway tunnel[J]. Highway, 2016, 61(2): 201-208 (in Chinese).
[6] 金南国,金贤玉,郭剑飞.混凝土孔结构与强度关系模型研究[J].浙江大学学报(工学版),2005,39(11):1680-1684.
JIN N G, JIN X Y, GUO J F. Relationship modeling of pore structure and strength of concrete[J]. Journal of Zhejiang University (Engineering Science), 2005, 39(11): 1680-1684 (in Chinese).
[7] 杜修力,金浏.含孔隙混凝土复合材料有效力学性能研究[J].工程力学,2012,29(6):70-77.
DU X L, JIN L. Research on effective mechanical properties of concrete composite material with pores[J]. Engineering Mechanics, 2012, 29(6): 70-77 (in Chinese).
[8] 杜修力,金浏.考虑孔隙及微裂纹影响的混凝土宏观力学特性研究[J].工程力学,2012,29(8):101-107.
DU X L, JIN L. Research on the influence of pores and micro-cracks on the macro-mechanical properties of concrete[J]. Engineering Mechanics, 2012, 29(8): 101-107 (in Chinese).
[9] 肖诗云,朱梁.孔隙对混凝土宏观力学性质的影响[J].沈阳建筑大学学报(自然科学版),2016,32(4):608-618.
XIAO S Y, ZHU L. Study on effects of voids on macro-mechanical properties of concrete[J]. Journal of Shenyang Jianzhu University (Natural Science), 2016, 32(4): 608-618 (in Chinese).
[10] YAMAN I O, HEARN N, AKTAN H M. Active and non-active porosity in concrete part I: experimental evidence[J]. Materials and Structures, 2002, 35(2): 102-109.
[11] 孙振江.考虑初始缺陷的混凝土压缩试验[J].低温建筑技术,2014,36(2):22-24.
SUN Z J. Uniaxial compression tests on concrete with initial imprfections[J]. Low Temperature Architecture Technology, 2014, 36(2): 22-24 (in Chinese).
[12] AMIANTI M, BOTARO V R. Recycling of EPS: a new methodology for production of concrete impregnated with polystyrene (CIP)[J]. Cement and Concrete Composites, 2008, 30(1): 23-28.
[13] MILED K, SAB K, ROY R L. Particle size effect on EPS lightweight concrete compressive strength: experimental investigation and modelling[J]. Mechanics of Materials, 2007, 39(3): 222-240.
[14] 邓朝莉,李宗利.孔隙率对混凝土力学性能影响的试验研究[J].混凝土,2016(7):41-44.
DENG C L, LI Z L. Experimental study on mechanical properties of concrete with porosity[J]. Concrete, 2016(7): 41-44 (in Chinese).
[15] 常西亚,卢爱红,胡善超,等.孔隙率对混凝土力学性能及能量耗散的影响研究[J].新型建筑材料,2019,46(4):12-15.
CHANG X Y, LU A H, HU S C, et al. Influence of porosity on mechanical properties and energy dissipation of concrete[J]. New Building Materials, 2019, 46(4): 12-15 (in Chinese).
[16] 罗甜恬,刘卫森,郭英健,等.再生聚苯乙烯在混凝土中的应用研究综述[J].硅酸盐通报,2021,40(1):133-145.
LUO T T, LIU W S, GUO Y J, et al. Review on applied research of recycled expanded polystyrene in concrete[J]. Bulletin of the Chinese Ceramic Society, 2021, 40(1): 133-145 (in Chinese).
[17] 方黄磊,缪林昌,尤佺,等.基于正交试验的EPS塑性混凝土配合比优化设计[J].硅酸盐通报,2018,37(2):436-440+455.
FANG H L, MIAO L C, YOU Q, et al. Optimum design of EPS plastic concrete mixing ratio based on orthogonal test[J]. Bulletin of the Chinese Ceramic Society, 2018, 37(2): 436-440+455 (in Chinese).
[18] 陈兵,涂思炎,翁友法.EPS轻质混凝土性能研究[J].建筑材料学报,2007,10(1):26-31.
CHEN B, TU S Y, WENG Y F. Study on the properties of lightweight expanded polystyrene concrete[J]. Journal of Building Materials, 2007, 10(1): 26-31 (in Chinese).
[19] 邓朝莉.初始缺陷对混凝土力学性能影响研究[D].杨凌:西北农林科技大学,2016.
DENG C L. The effect of mechanical properties of concrete with initial defect[D]. Yangling: Northwest A&F University, 2016 (in Chinese).
[20] 徐礼华,黄彪,李彪,等.循环荷载作用下聚丙烯纤维混凝土受压应力-应变关系研究[J].土木工程学报,2019,52(4):1-12.
XU L H, HUANG B, LI B, et al. Study on the stress-strain relation of polypropylene fiber reinforced concrete under cyclic compression[J]. China Civil Engineering Journal, 2019, 52(4): 1-12 (in Chinese).