双层电解质极限电流型氧传感器的制备及其性能

硅酸盐通报 ›› 2018, Vol. 37 ›› Issue (2): 541-546.

双层电解质极限电流型氧传感器的制备及其性能

梁斌;周芬;谢敏;郜建全;包金小;宋希文

内蒙古科技大学材料与冶金学院,包头,014010

出版日期:2018-02-15 发布日期:2021-01-18
基金资助:
国家自然科学基金(51464038)%内蒙古自治区高等学校科学研究项目(NJZY14168)

Preparation and Properties of Limiting Current Oxygen Sensor with Bilayer Electrolyte

LIANG Bin;ZHOU Fen;XIE Min;GAO Jian-quan;BAO Jin-xiao;SONG Xi-wen

Online:2018-02-15 Published:2021-01-18

摘要/Abstract

摘要： 以LaNi0.6Fe0.4O3-δ(LNF)为致密扩散层材料,以8YSZ(8mol％ Y2O3+ ZrO2)和Ce0.9Gd0.1O1.95(GDC)为固体电解质材料,采用共压-共烧法制备了双层电解质型致密扩散障极限电流氧传感器,研究了氧含量和温度对氧传感器氧敏性能的影响.实验结果表明:氧传感器在800～820℃温度范围,氧含量在0.3％～1.2％气氛下,显示出良好的极限电流平台,氧传感器的响应时间和恢复时间分别约为35 s和45 s.极限电流与氧浓度ψ(O2)之间存在较好的线性关系,并且氧传感器log(IL·T)-1/T曲线线性相关.

关键词: 氧传感器;极限电流;双层电解质;致密扩散障层

Abstract: A new limiting current oxygen sensor using LaNi0.6Fe0.4O3-δ (LNF) as dense diffusion barrier and 8YSZ (8mol％ Y2O3 + ZrO2) and Ce0.9 Gd0.1O1.95 (GDC) as electrolyte layer was developed successfully via co-pressing and co-sintering method.The influences of temperature and oxygen content on oxygen sensitive characteristic for oxygen sensor were measured.The results indicate that the sensors exhibit better current plateaus at 800-820 ℃ with oxygen concentration varying from 0.3％ to 1.2％.The response/recovery times of oxygen sensor are about 35 s and 45 s,respectively.The limiting current has a good lihear relationship with oxygen concentration.And the curves of log(IL · T)-1/T for oxygen sensor are linear correlation.

Key words: oxygen sensor;limiting current;bilayer electrolyte;dense diffusion barrier

中图分类号:

TP212.2

梁斌;周芬;谢敏;郜建全;包金小;宋希文. 双层电解质极限电流型氧传感器的制备及其性能[J]. 硅酸盐通报, 2018, 37(2): 541-546.

LIANG Bin;ZHOU Fen;XIE Min;GAO Jian-quan;BAO Jin-xiao;SONG Xi-wen. Preparation and Properties of Limiting Current Oxygen Sensor with Bilayer Electrolyte[J]. BULLETIN OF THE CHINESE CERAMIC SOCIETY, 2018, 37(2): 541-546.