欢迎访问《硅酸盐通报》官方网站,今天是

硅酸盐通报 ›› 2025, Vol. 44 ›› Issue (3): 992-1000.

• 资源综合利用 • 上一篇    下一篇

福建某钨矿重选尾矿中石英制备硅微粉研究

马博华1,2, 杨思原1,2, 李克尧1,2, 任浩1,2, 叶子乾1,2, 包申旭1,2   

  1. 1.武汉理工大学关键非金属矿产资源绿色利用教育部重点实验室,武汉 430070;
    2.武汉理工大学资源与环境工程学院,武汉 430070
  • 收稿日期:2024-10-11 修订日期:2024-11-22 出版日期:2025-03-15 发布日期:2025-04-01
  • 通信作者: 杨思原,博士,教授。E-mail:siyuan.yang@whut.edu.cn
  • 作者简介:马博华(1999—),男,硕士研究生。主要从事矿物加工工程的研究。E-mail:bohua.ma@whut.edu.cn
  • 基金资助:
    国家重点研发计划(2022YFE0126800);中国工程院战略研究与咨询项目(2024-DFZD-01);国家自然科学基金(52374276)

Preparation of Silicon Micropowder from Quartz in Gravity Separation Tailings of Tungsten Mine in Fujian

MA Bohua1,2, YANG Siyuan1,2, LI Keyao1,2, REN Hao1,2, YE Ziqian1,2, BAO Shenxu1,2   

  1. 1. Key Laboratory of Green Utilization of Key Nonmetallic Mineral Resources, Ministry of Education, Wuhan University of Technology, Wuhan 430070, China;
    2. School of Resources and Environmental Engineering, Wuhan University of Technology, Wuhan 430070, China
  • Received:2024-10-11 Revised:2024-11-22 Published:2025-03-15 Online:2025-04-01

摘要: 硅微粉是一种重要的无机非金属材料,主要由石英砂或岩石经过破碎、粉磨、分级、提纯等一系列加工过程而得到,通常具有较高的纯度和较小的粒径分布。本文以福建某钨矿重选尾矿综合利用分离出的石英产品为原料,通过浮选-酸浸-超细磨-离子清洗-改性等工艺成功制备出超细硅微粉产品。结果表明,超细硅微粉的主要化学成分(质量分数)为SiO2(99.820 0%)、Fe2O3(0.001 8%)、Al2O3(0.041 0%),水萃取液的pH值为7.08,电导率为6.26 μS/cm,Na+浓度为0.24 ppm(1 ppm=10-6)、Cl-浓度为2.94 ppm,吸油值为21.36 g/100 g,这些指标均优于《电子及电器工业用二氧化硅微粉》(SJ/T 10675—2002)电子级活性硅微粉的质量要求。本研究为矿山金属尾矿高值化有效利用提供了思路和方法,对于促进资源循环利用和环境保护具有积极的意义。

关键词: 硅微粉, 钨尾矿, 低品位石英, 有机改性, 超细磨

Abstract: Silica micropowder is an important inorganic non-metallic material, which is mainly obtained from quartz sand or rock through a series of processes such as crushing, grinding, grading and purification. It usually has high purity and small particle size distribution. In this paper, the ultrafine silicon micropowder product was successfully prepared by flotation, acid leaching, ultrafine grinding, ion cleaning and modification using quartz product separated from gravity separation tailings of tungsten mine in Fujian as raw material. The results show that the main chemical composition (mass fraction) of ultrafine silicon micropowder is SiO2 (99.820 0%), Fe2O3 (0.001 8%), Al2O3 (0.041 0%), the pH value of water extract is 7.08, the conductivity is 6.26 μS/cm, the concentration of Na+ is 0.24 ppm (1 ppm=10-6), the concentration of Cl- is 2.94 ppm, and the oil absorption value is 21.36 g/100 g. These indexes are better than the quality requirements of electronic grade active microsilicon powder of “Silicon dioxide powder for electronic and electrical industry”(SJ/T 10675—2002). This study provides ideas and methods for the effective utilization of high-value metal tailings in mines, and has positive significance for promoting resource recycling and environmental protection.

Key words: silicon micropowder, tungsten tailing, low grade quartz, organic modification, ultrafine grinding

中图分类号: