欢迎访问《硅酸盐通报》官方网站,今天是
分享到:

硅酸盐通报 ›› 2023, Vol. 42 ›› Issue (2): 637-643.

所属专题: 资源综合利用

• 资源综合利用 • 上一篇    下一篇

多源石墨固废制备电热板材配方试验研究

李思颖1, 任子杰1,2, 高惠民1,2, 马骏辉1, 杨云平1, 吕阳3,4, 李相国3,4   

  1. 1.武汉理工大学资源与环境工程学院,武汉 430070;
    2.矿物资源加工与环境湖北省重点实验室,武汉 430070;
    3.武汉理工大学材料科学与工程学院,武汉 430070;
    4.武汉理工大学硅酸盐建筑材料国家重点实验室,武汉 430070
  • 收稿日期:2022-10-26 修订日期:2022-11-30 出版日期:2023-02-15 发布日期:2023-03-07
  • 通信作者: 任子杰,博士,副教授。E-mail:renzijie@whut.edu.cn
  • 作者简介:李思颖(1998—),女,硕士研究生。主要从事非金属矿的研究。E-mail:843448231@qq.com
  • 基金资助:
    科技部重点研发计划(2020YFC1909605)

Experimental Study on Formula of Electrothermal Plate Prepared from Multi-Source Graphite Solid Waste

LI Siying1, REN Zijie1,2, GAO Huimin1,2, MA Junhui1, YANG Yunping1, LYU Yang3,4, LI Xiangguo3,4   

  1. 1. School of Resources and Environment Engineering, Wuhan University of Technology, Wuhan 430070, China;
    2. Hubei Province Key Laboratory of Mineral Resources Processing and Environment, Wuhan 430070, China;
    3. School of Materials Science and Engineering, Wuhan University of Technology, Wuhan 430070, China;
    4. State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology, Wuhan 430070, China
  • Received:2022-10-26 Revised:2022-11-30 Online:2023-02-15 Published:2023-03-07

摘要: 为了提高石墨固废利用率,本文以石墨开采废石为细骨料,添加球形石墨尾料以及不同质量分数的废石石粉进行电热板材配方试验,探究了石墨开采废石取代量、石粉掺量对电热板材性能的影响。结果表明:在100%(质量分数)使用石墨开采废石作为细骨料时,养护28 d的水泥板材抗折强度及抗压强度分别达到11.09 MPa和50.90 MPa,虽然略低于使用标准砂的水泥板材的强度指标,但是仍可满足相关要求,说明石墨开采废石可以作为细骨料使用;在废石石粉掺量为7%(质量分数)时,电热板材的抗折强度和抗压强度最高分别达到6.21 MPa和33.00 MPa,虽然强度有所降低,但是仍可满足低强度板材的要求;在球形石墨尾料掺量为9%(质量分数)时,电热板材体积电阻率为1.94 Ω·m,发热温度为71 ℃,具有良好的电热效果。

关键词: 石墨固废, 电热板材, 球形石墨尾料, 力学性能, 电学性能, 体积电阻率

Abstract: In order to improve the utilization rate of graphite solid waste, this paper used graphite mining waste stone as fine aggregate, added spherical graphite tailing and waste stone stone powder with different mass fraction to carry out an experimental study on the formula of electrothermal plate. The influences of graphite mining waste stone replacement and stone powder content on the performance of electrothermal plate were explored. The results show that using 100% (mass fraction) graphite mining waste stone as fine aggregate, the bending strength and compressive strength of cement plate maintained for 28 d are 11.09 MPa and 50.90 MPa, respectively. Although they are slightly lower than the strength index of cement plate using standard sand, but they meet the relevant requirements. This shows that graphite mining waste stone can be used as fine aggregate. When waste stone stone powder content is 7% (mass fraction), the bending strength and compressive strength of electrothermal plate reach up to 6.21 MPa and 33.00 MPa. Although the strength is reduced, it can still meet the requirements of low-strength plate. When spherical graphite tailing content is 9% (mass fraction), the volume resistivity of electrothermal plate is 1.94 Ω·m, and the heating temperature is 71 ℃, which has a good electrothermal effect.

Key words: graphite solid waste, electrothermal plate, spherical graphite tailing, mechanical property, electrical performance, volume resistivity

中图分类号: