欢迎访问《硅酸盐通报》官方网站,今天是
分享到:

硅酸盐通报 ›› 2022, Vol. 41 ›› Issue (5): 1677-1688.

• 资源综合利用 • 上一篇    下一篇

粉煤灰掺量对海水海砂高性能混凝土性能的影响

张腾腾1, 王传林1,2, 张宇轩1, 刘泽平1   

  1. 1.汕头大学土木与环境工程系,汕头 515063;
    2.汕头大学广东省结构安全与监测工程技术研究中心,汕头 515063
  • 收稿日期:2021-10-27 修回日期:2022-03-27 出版日期:2022-05-15 发布日期:2022-06-01
  • 通讯作者: 王传林,博士,讲师。E-mail:clwang@stu.edu.cn
  • 作者简介:张腾腾(1996—),女,硕士研究生。主要从事海水海砂混凝土的研究。E-mail:1710780706@qq.com
  • 基金资助:
    广东高校重点平台和科研项目(2021KQNCX021);汕头大学科研启动经费项目(NTF17011)

Effect of Fly Ash Content on Performance of High Performance Concrete with Seawater and Sea Sand

ZHANG Tengteng1, WANG Chuanlin1,2, ZHANG Yuxuan1, LIU Zeping1   

  1. 1. Department of Civil and Environmental Engineering, Shantou University, Shantou 515063, China;
    2. Guangdong Structural Safety and Monitoring Engineering Technology Research Center, Shantou University, Shantou 515063, China
  • Received:2021-10-27 Revised:2022-03-27 Online:2022-05-15 Published:2022-06-01

摘要: 通过宏观力学性能、化学收缩、pH值、氯离子浓度等测试和SEM、XRD等微观表征研究粉煤灰掺量对海水海砂高性能混凝土性能的影响。结果表明:为维系钢筋钝化膜稳定,高温蒸养时粉煤灰掺量不宜大于30%(质量分数,下同),标养时粉煤灰掺量不宜大于50%;海水海砂高性能混凝土中游离Cl-浓度随养护时间波动,前期先升高后骤降,后期缓慢增加,标养条件下Cl-浓度明显低于高温蒸养条件下;海水海砂高性能混凝土具有早强性,其强度随粉煤灰掺量增加大致呈下降趋势,高温蒸养可明显提高混凝土抗折、抗压强度;粉煤灰掺量越多,残留的未水化颗粒越多,高温蒸养可有效改善混凝土微观结构,提高致密性;粉煤灰掺量过多或过少均会增加硅酸盐水泥体系的化学收缩,粉煤灰掺量为30%和40%时混凝土化学收缩值较小。

关键词: 海水海砂, 高性能混凝土, 粉煤灰, 高温蒸养, 标养, 水化机理

Abstract: The effect of fly ash content on the performance of seawater and sea sand high performance concrete was studied by carrying out experiments on mechanical properties, chemical shrinkage, pH value, chloride ion concentration, and microstructure. The results show that in order to maintain the stability of reinforcement passive film, the content of fly ash should not be greater than 30% (mass fraction, the same below) under high temperature steam curing and 50% under standard curing. The concentration of free Cl- in seawater and sea sand high performance concrete fluctuates with curing time, increases first and then decreases sharply in the early stage, and increases slowly in the later stage. The Cl- concentration under standard curing is significantly lower than that under high temperature steam curing. Seawater and sea sand high performance concrete has early strength, and its strength decreases with the increase of fly ash content. High temperature steam curing significantly improves the flexural and compressive strength of concrete. The more fly ash is added, the more unhydrated particles remain. High temperature steam curing effectively improves the microstructure and compactness of concrete. When fly ash content is too large or too small, it increases the chemical shrinkage of Portland cement. The chemical shrinkage value of concrete is small when the fly ash content is 30% and 40%.

Key words: seawater and sea sand, high performance concrete, fly ash, high temperature steam curing, standard curing, hydration mechanism

中图分类号: