欢迎访问《硅酸盐通报》官方网站,今天是
分享到:

硅酸盐通报 ›› 2022, Vol. 41 ›› Issue (1): 182-191.

所属专题: 资源综合利用

• 资源综合利用 • 上一篇    下一篇

低碱度水泥基材料固化模拟放射性焚烧灰性能与机理研究

韦琦1,2, 耿海宁3, 马浩森2, 刘艳4, 陈伟1, 王东文4, 潘社奇4, 李秋1   

  1. 1.武汉理工大学硅酸盐建筑材料国家重点实验室,武汉 430070;
    2.武汉理工大学材料科学与工程学院,武汉 430070;
    3.湖北城市建设职业技术学院,武汉 430205;
    4.中国工程物理研究院材料研究所,绵阳 621907
  • 收稿日期:2021-08-26 修订日期:2021-09-29 出版日期:2022-01-15 发布日期:2022-02-10
  • 通信作者: 李 秋,博士,研究员。E-mail: Qiu-Li@whut.edu.cn
  • 作者简介:韦 琦(1998—),男,硕士研究生。主要从事中低放射性废物水泥固化研究。E-mail:1530574040@qq.com
  • 基金资助:
    国家自然科学基金面上项目(52072279);中国工程物理研究院横向科研项目;硅酸盐建筑材料国家重点实验室(武汉理工大学)开放基金(SYSJJ2021-12);深圳市科技计划项目协同创新专项(CJGJZD20200617102601003)

Properties and Mechanism of Solidification of Simulated Radioactive Incineration Ash with Low Alkalinity Cement-Based Materials

WEI Qi1,2, GENG Haining3, MA Haosen2, LIU Yan4, CHEN Wei1, WANG Dongwen4, PAN Sheqi4, LI Qiu1   

  1. 1. State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology, Wuhan 430070, China;
    2. School of Materials Science and Engineering, Wuhan University of Technology, Wuhan 430070, China;
    3. Hubei Urban Construction Vocational and Technological College, Wuhan 430205, China;
    4. Institute of Materials, China Academy of Engineering Physics, Mianyang 621907, China
  • Received:2021-08-26 Revised:2021-09-29 Online:2022-01-15 Published:2022-02-10

摘要: 放射性焚烧灰中存在铝单质金属,其在碱激发水泥或硅酸盐水泥的高碱性孔溶液环境下会反应产生氢气,造成固化体膨胀与性能劣化。为克服此问题,本研究以水泥、硅灰和粉煤灰为主要原料,添加沸石、聚羧酸减水剂、定优胶和聚合硫酸铝协同改性制备低碱度水泥基材料,开展低碱度水泥基材料对模拟放射性焚烧灰的固化处置研究。结果表明:模拟放射性焚烧灰质量包容量为30%的低碱度水泥基材料固化体的28 d抗压强度达16.6 MPa以上,抗冻融性能、抗浸泡性能及抗冲击性能均满足GB 14569.1—2011《低、中水平放射性废物固化体性能要求-水泥固化体》的要求。Ce3+第42 d浸出率为4.41×10-9 cm/d,累计浸出分数为3.4×10-7 cm。低碱度水泥基材料固化模拟放射性焚烧灰过程中未产生大量氢气,其原因是,在早期孔溶液pH值较低,同时孔溶液中的高钙离子浓度延缓了焚烧灰中的单质铝与孔溶液发生反应释放氢气的速度,在后期孔溶液pH值低于11.75,焚烧灰中的单质铝不会与孔溶液发生反应。

关键词: 固废处置, 水泥基材料, 低碱度, 放射性焚烧灰, 单质金属, 固化, 浸出率, 累积浸出分数

Abstract: The existence of metallic aluminum in the radioactive incineration ash results in the expansion and deterioration of cement waste forms, due to the reaction of metallic aluminum with high alkali pore solution to produce hydrogen gas in hardened Portland cement or alkali-activated cementitious materials. In this study, low alkalinity cement-based materials were prepared by Portland cement, silica fume and fly ash as the main raw materials, aiming to overcome this problem. Zeolite, polycarboxylate superplasticizer, diutan gum and polyaluminum sulfate were used as well to modify the properties. According to the results, 28 d compressive strength of over 16.6 MPa is achieved by low alkalinity cement-based materials waste forms with 30% (in mass) simulated radioactive incineration ash. The freeze-thaw resistance, immersion resistance and impact resistance meet the requirements of GB 14569.1—2011 specifications. The leaching rate of Ce3+ on the 42 d is 4.41×10-9 cm/d, and the cumulative leaching fraction is 3.4×10-7 cm. The relatively lower pH value of pore solution in the early age and high Ca concentration in pore solution hinders the reaction between the metallic Al and pore solution. At later age, no reaction between metallic Al and pore solution because the pH value of pore solution is below 11.75.

Key words: solid waste disposal, cement-based material, low alkalinity, radioactive incineration ash, elemental metal, solidification, leaching rate, cumulative leaching fraction

中图分类号: