欢迎访问《硅酸盐通报》官方网站,今天是
分享到:

硅酸盐通报 ›› 2021, Vol. 40 ›› Issue (2): 534-541.

所属专题: 资源综合利用

• 资源综合利用 • 上一篇    下一篇

锑尾矿粉基复合胶凝材料的制备及水化特性

王浩1, 邓航2, 刘数华1   

  1. 1.武汉大学,水资源与水电工程科学国家重点实验室,武汉 430072;
    2.贵州华电乌江水电工程项目管理有限公司,贵阳 550002
  • 收稿日期:2020-09-09 修回日期:2020-09-18 出版日期:2021-02-15 发布日期:2021-03-10
  • 通讯作者: 刘数华,教授。E-mail:shliu@whu.edu.cn
  • 作者简介:王 浩(1996—),男,硕士研究生。主要从事建筑材料方向的研究。E-mail:wanghao6312@whu.edu.cn
  • 基金资助:
    国家重点研发计划(2018YFC1801704)

Preparation and Hydration Characteristics of Antimony Tailings Powder-Based Composite Cementitious Material

WANG Hao1, DENG Hang2, LIU Shuhua1   

  1. 1. State Key Laboratory of Water Resources and Hydropower Engineering Science, Wuhan University, Wuhan 430072, China;
    2. Guizhou Huadian Wujiang Hydropower Engineering Project Management Co., Ltd., Guiyang 550002, China
  • Received:2020-09-09 Revised:2020-09-18 Online:2021-02-15 Published:2021-03-10

摘要: 以锑尾矿微粉作为主要原料,辅以水泥熟料、活化剂和促凝剂制备锑尾矿粉基复合胶凝材料,并从力学性能及微观结构等方面对复合胶凝材料的水化特性进行探究。结果表明,试件浆体的抗压强度随着锑尾矿微粉掺量的增加而减小,质量掺量为70%时仍满足尾矿固化筑坝要求。不同活化剂对复合胶凝材料强度的影响显著不同,当掺入磷石膏和生石灰且其质量比例为2∶1时,试件活化效果最好,7 d抗压强度达到10.42 MPa。试件浆体的最终水化产物主要为C-S-H凝胶和氢氧化钙,此外还有少量钙矾石生成。选择铝酸盐水泥作为促凝剂且质量掺量为3%时,能有效缩短试件凝结时间,满足快速固化的要求。同时利用锑尾矿粉基复合胶凝材料可以实现细粒锑尾矿的快速原位固化。

关键词: 锑尾矿, 固化, 活化剂, 强度, 水化特性

Abstract: Antimony tailings fine powder was used as the main raw material, supplemented with cement clinker, activator and accelerator to prepare antimony tailings powder-based composite cementitious material. Hydration characteristics of composite cementitious materials in terms of mechanical properties and microstructure were investigated. The results show that compressive strength of specimen slurry decreases with the increase of the amount of antimony tailings fine powder. When the mass fraction of admixture is 70%, it still meets the requirements of tailings solidification and damming. Effects of different activators on the strength of composite cementitious materials are significantly different. When phosphogypsum and quicklime are mixed and the mass ratio is 2∶1, the activition effect of specimen is the best, and compressive strength reaches 10.42 MPa in 7 d. The final hydration products of specimen slurry are mainly C-S-H gel, calcium hydroxide, and a small amount of ettringite. When aluminate cement is selected as the accelerator and the mass fraction is 3%, it effectively shortens the setting time of specimen and meets the requirements of rapid solidification. The use of antimony tailings powder-based composite cementitious material achieves rapid in-situ solidification of fine-grain antimony tailings.

Key words: antimony tailing, solidification, activator, strength, hydration characteristic

中图分类号: