欢迎访问《硅酸盐通报》官方网站,今天是
分享到:

硅酸盐通报 ›› 2025, Vol. 44 ›› Issue (1): 223-230.DOI: 10.16552/j.cnki.issn1001-1625.2024.0784

• 资源综合利用 • 上一篇    下一篇

氟石膏水化活性改性试验研究

薛璐韬1,2, 李育彪1,2, 吴晓勇1,2, 李瑞1,2, 孙旭超1,2, 吴开振1,2, 池汝安3   

  1. 1.关键非金属矿产资源绿色利用教育部重点实验室,武汉 430070;
    2.武汉理工大学资源与环境工程学院,武汉 430070;
    3.湖北三峡实验室,宜昌 443000
  • 收稿日期:2024-07-08 修订日期:2024-08-27 出版日期:2025-01-15 发布日期:2025-01-23
  • 通信作者: 李育彪,博士,教授。E-mail:Yubiao.Li@whut.edu.cn
  • 作者简介:薛璐韬(2001—),男,硕士研究生。主要从事固废资源化的研究。E-mail:302689@whut.edu.cn
  • 基金资助:
    湖北省科技重大专项(2022ACA004-6);湖北三峡实验室创新基金项目(SC232019)

Experimental Study on Hydration Activity Modification of Fluorgypsum

XUE Lutao1,2, LI Yubiao1,2, WU Xiaoyong1,2, LI Rui1,2, SUN Xuchao1,2, WU Kaizhen1,2, CHI Ru’an3   

  1. 1. Key Laboratory of Green Utilization of Critical Non-Metallic Mineral Resources, Ministry of Education, Wuhan 430070, China;
    2. School of Resources and Environmental Engineering, Wuhan University of Technology, Wuhan 430070, China;
    3. Hubei Three Gorges Laboratory, Yichang 443000, China
  • Received:2024-07-08 Revised:2024-08-27 Published:2025-01-15 Online:2025-01-23

摘要: 氟石膏的强酸性与较低水化活性限制了其在抹灰石膏领域的应用,为解决这一难题,本文选用CaO、Ca(OH)2为中和剂,Na2C2O4、Na2SO4、K2SO4、K2SiO3、半水石膏为激发剂,对氟石膏水化活性进行改性,探究中和剂与激发剂种类、掺量对改性效果的影响。结果表明:3%(质量分数)的中和剂可以将氟石膏pH值提高至9左右,并使氟石膏中游离氟含量维持在0.02%(质量分数)左右,基于成本考虑,选择价格更低的CaO为中和剂;K2SO4、Na2SO4和半水石膏作为激发剂均有较好的激发效果,其中Na2SO4激发效果最好,经1.0%(质量分数)Na2SO4激发制备的抹灰石膏初凝时间为119 min,终凝时间为252 min,抗压强度为10.30 MPa,抗折强度为3.85 MPa,各项指标均达到《抹灰石膏》(GB/T 28627—2023)的要求。

关键词: 氟石膏, 中和剂, 激发剂, 凝结时间, 抗压强度, 抗折强度, 水化率

Abstract: The high acidity and low hydration activity of fluorgypsum restrict its application in the field of plastering gypsum. In order to solve this problem and promote the large-scale application of fluorgypsum in plastering gypsum, CaO and Ca(OH)2 were selected as neutralizer while Na2C2O4, Na2SO4, K2SO4, K2SiO3 and gypsum hemihydrate were selected as activator, to modify fluorgypsum. The effects of type and dosage of activator and neutralizer on modification effect were investigated. The results show that 3%(mass fraction) neutralizer can improve the pH value of fluorgypsum to around 9 and keep its free fluorine content around 0.02% (mass fraction). Considering the cost, the cheaper CaO is choose as neutralizer. In addition, K2SO4, Na2SO4 and gypsum hemihydrate as activator have good excitation effect, among which Na2SO4 has the best excitation effect. Plastering gypsum excited by 1.0% (mass fraction) Na2SO4 is prepared, with initial setting time of 119 min and final setting time of 252 min. Moreover, the compressive strength is 10.30 MPa while the flexural strength is 3.85 MPa. It should be noted that all indicators reach the requirements of “Plastering gypsum”(GB/T 28627—2023).

Key words: fluorgypsum, neutralizer, activator, setting time, compressive strength, flexural strength, hydration rate

中图分类号: