基于磁场定向钢纤维的高性能混凝土性能研究

硅酸盐通报 ›› 2024, Vol. 43 ›› Issue (8): 2848-2857.

基于磁场定向钢纤维的高性能混凝土性能研究

刘同军¹, 张冲², 徐笃军¹, 张继才¹, 李芳¹, 张秀芝²

1.中国电建集团山东电力管道工程有限公司,济南 250117;
2.济南大学材料科学与工程学院,济南 250022

收稿日期:2024-01-04 修订日期:2024-02-27 出版日期:2024-08-15 发布日期:2024-08-12
通信作者: 张秀芝,博士,教授。E-mail:mse_zhangxz@ujn.edu.cn
作者简介:刘同军(1974—),男,高级工程师。主要从事高性能混凝土及其制品方面的研究。E-mail:50558584@qq.com
基金资助:
国家自然科学基金(52178211,51778269);济南市科研带头人工作室项目(2021GXRC087)

Performance of High Performance Concrete Based on Magnetic Field Oriented Steel Fiber

LIU Tongjun¹, ZHANG Chong², XU Dujun¹, ZHANG Jicai¹, LI Fang¹, ZHANG Xiuzhi²

1. Power China Shandong Pipeline Engineering Corporation Limited, Jinan 250117, China;
2. School of Materials Science and Engineering, University of Jinan, Jinan 250022, China

Received:2024-01-04 Revised:2024-02-27 Online:2024-08-15 Published:2024-08-12

摘要/Abstract

摘要： 本文利用磁铁设计了一种高性能混凝土中钢纤维的定向方法,通过改变减水剂掺量调节混凝土的工作性能,研究了钢纤维定向效果与混凝土流变性能、力学性能的关系。结果表明,随着聚羧酸减水剂质量分数增大,混凝土屈服应力和塑性黏度逐渐降低,流动度增大。当减水剂质量分数大于2.5%后,屈服应力和流动度逐渐趋于稳定,但塑性黏度仍保持降低趋势。屈服应力和塑性黏度越低,纤维定向效果越好。未定向的钢纤维方向系数在0.479~0.526,而在磁场作用下定向的钢纤维方向系数为0.815~0.912,掺入定向钢纤维后混凝土抗折强度提升了24.0%~43.3%,韧性指数I₂₀提升了38.4%~69.9%。此外,磁场对钢纤维分散性没有明显影响,定向试件与未定向试件的抗压强度无明显差异。

关键词: 高性能混凝土, 钢纤维, 定向, 流变性能, 力学性能

Abstract: In this paper, a directional method of steel fiber in high performance concrete was designed by using magnet. The working performance of concrete was adjusted by changing the amount of water reducing agent. The relationship between the directional effect of steel fiber and the rheological properties and mechanical properties of concrete was studied. The results show that with the increase of mass fraction of polycarboxylate superplasticizer, the yield stress and plastic viscosity of concrete decrease gradually, and the fluidity increases. When the mass fraction of water reducer is greater than 2.5%, the yield stress and fluidity gradually tend to be stable, but the plastic viscosity still maintains a decreasing trend. The lower the yield stress and plastic viscosity is, the better the fiber orientation effect is. The directional coefficient of unoriented steel fiber is 0.479~0.526, while the directional coefficient of steel fiber under magnetic field is 0.815~0.912. The flexural strength of concrete with oriented steel fiber increases by 24.0%~43.3%, and the toughness index I₂₀ increases by 38.4%~69.9%. In addition, the magnetic field has no obvious effect on the dispersion of steel fiber, and there is no significant difference in compressive strength between oriented specimen and unoriented specimen.

Key words: high performance concrete, steel fiber, orientation, rheological property, mechanical property

中图分类号:

TU528

刘同军, 张冲, 徐笃军, 张继才, 李芳, 张秀芝. 基于磁场定向钢纤维的高性能混凝土性能研究[J]. 硅酸盐通报, 2024, 43(8): 2848-2857.

LIU Tongjun, ZHANG Chong, XU Dujun, ZHANG Jicai, LI Fang, ZHANG Xiuzhi. Performance of High Performance Concrete Based on Magnetic Field Oriented Steel Fiber[J]. BULLETIN OF THE CHINESE CERAMIC SOCIETY, 2024, 43(8): 2848-2857.

参考文献

[1] WANG S W, WANG B, ZHU H T, et al. Ultra-high performance concrete: mix design, raw materials and curing regimes: a review[J]. Materials Today Communications, 2023, 35: 105468.
[2] TRABUCCHI I, TIBERTI G, CONFORTI A, et al. Experimental study on steel fiber reinforced concrete and reinforced concrete elements under concentrated loads[J]. Construction and Building Materials, 2021, 307: 124834.
[3] AKEED M H, QAIDI S, AHMED H U, et al. Ultra-high-performance fiber-reinforced concrete. Part III: fresh and hardened properties[J]. Case Studies in Construction Materials, 2022, 17: e01265.
[4] RAJU R A, LIM S, AKIYAMA M, et al. Effects of concrete flow on the distribution and orientation of fibers and flexural behavior of steel fiber-reinforced self-compacting concrete beams[J]. Construction and Building Materials, 2020, 262: 119963.
[5] 宋秋磊. 钢纤维分布对超高性能混凝土性能影响及调控研究[D]. 武汉: 武汉理工大学, 2021.
SONG Q L. Study on the effect of steel fibre distribution on the performance of ultra high performance concrete and its regulation[D]. Wuhan: Wuhan University of Technology, 2021 (in Chinese).
[6] 张冲, 毕梦迪, 刘同军, 等. 砂浆流变性能和外界磁场强度对钢纤维分布特征的影响[J]. 材料导报, 2022, 36(24): 74-79.
ZHANG C, BI M D, LIU T J, et al. Effects of rheological properties of mortar and magnetic field strength on steel fiber distribution characteristics[J]. Materials Reports, 2022, 36(24): 74-79 (in Chinese).
[7] ZHOU B, UCHIDA Y. Relationship between fiber orientation/distribution and post-cracking behaviour in ultra-high-performance fiber-reinforced concrete (UHPFRC)[J]. Cement and Concrete Composites, 2017, 83: 66-75.
[8] SONG Q L, YU R, SHUI Z H, et al. Optimization of fibre orientation and distribution for a sustainable ultra-high performance fibre reinforced concrete (UHPFRC): experiments and mechanism analysis[J]. Construction and Building Materials, 2018, 169: 8-19.
[9] 林建军. 水泥基材料中钢纤维的方向控制及增强效应研究[D]. 天津: 河北工业大学, 2015.
LIN J J. Investigation on orientation control and enhancement effect of steel fibers in cementitious materials[D]. Tianjin: Hebei University of Technology, 2015 (in Chinese).
[10] 张秀芝, 毕梦迪, 刘同军, 等. 钢纤维混凝土中纤维分布特性影响因素研究进展[J]. 硅酸盐学报, 2021, 49(8): 1732-1742.
ZHANG X Z, BI M D, LIU T J, et al. Research progress in factors affecting fiber distribution in steel fiber concrete[J]. Journal of the Chinese Ceramic Society, 2021, 49(8): 1732-1742 (in Chinese).
[11] 慕儒, 赵全明, 田稳苓. 单向分布钢纤维增强水泥浆的制备与性能研究[J]. 河北工业大学学报, 2012, 41(2): 101-104.
MU R, ZHAO Q M, TIAN W L. Investigation on the preparation and properties of aligned steel fibre reinforce cement paste[J]. Journal of Hebei University of Technology, 2012, 41(2): 101-104 (in Chinese).
[12] HUANG H H, GAO X J, LI L S, et al. Improvement effect of steel fiber orientation control on mechanical performance of UHPC[J]. Construction and Building Materials, 2018, 188: 709-721.
[13] HUANG H H, SU A S, GAO X J, et al. Influence of formwork wall effect on fiber orientation of UHPC with two casting methods[J]. Construction and Building Materials, 2019, 215: 310-320.
[14] HUANG H H, GAO X J, TENG L. Fiber alignment and its effect on mechanical properties of UHPC: an overview[J]. Construction and Building Materials, 2021, 296: 123741.
[15] TENG L, MENG W N, KHAYAT K H. Rheology control of ultra-high-performance concrete made with different fiber contents[J]. Cement and Concrete Research, 2020, 138: 106222.
[16] 慕儒, 吴航鹏, 卿龙邦. 定向分布钢纤维增强水泥基圆孔板单轴拉伸性能试验研究[J]. 混凝土, 2021(8): 11-13+19.
MU R, WU H P, QING L B. Uniaxial tensile properties of aligned steel fiber reinforced cementitious composite plate with holes[J]. Concrete, 2021(8): 11-13+19 (in Chinese).
[17] ARUNOTHAYAN A R, NEMATOLLAHI B, RANADE R, et al. Fiber orientation effects on ultra-high performance concrete formed by 3D printing[J]. Cement and Concrete Research, 2021, 143: 106384.
[18] QIN Y, SU J X, CAO J, et al. Investigation of orientation coefficient on meso-damage evolution of steel fiber-reinforced cement composites[J]. Engineering Fracture Mechanics, 2023, 284: 109210.
[19] 慕儒, 邱欣, 赵全明, 等. 单向分布钢纤维增强水泥基复合材料(I): 钢纤维方向控制[J]. 建筑材料学报, 2015, 18(2): 208-213.
MU R, QIU X, ZHAO Q M, et al. Aligned steel fibre reinforced cement based composites(I): orientation control of steel fibres[J]. Journal of Building Materials, 2015, 18(2): 208-213 (in Chinese).
[20] ZHANG C, ZHANG X Z, HOU J, et al. Rheology and early microstructure evolution of fresh ultra-high performance concrete with polycarboxylate superplasticizer[J]. Case Studies in Construction Materials, 2022, 17: e01575.
[21] WANG X P, YU R, SONG Q L, et al. Optimized design of ultra-high performance concrete (UHPC) with a high wet packing density[J]. Cement and Concrete Research, 2019, 126: 105921.