欢迎访问《硅酸盐通报》官方网站,今天是
分享到:

硅酸盐通报 ›› 2021, Vol. 40 ›› Issue (1): 215-222.

所属专题: 资源综合利用

• 资源综合利用 • 上一篇    下一篇

油田污泥基高强陶粒的制备及性能优化

杨晓伟1, 张爱生1, 曲俊蓉2, 杨柯1, 许建华1, 朱英1   

  1. 1.齐鲁工业大学(山东省科学院)新材料研究所,济南 250014;
    2.青岛娄山河水务资源有限公司,青岛 266000
  • 收稿日期:2020-08-15 修回日期:2020-09-22 出版日期:2021-01-15 发布日期:2021-02-07
  • 通讯作者: 朱英,博士,研究员。E-mali:zhuyingee@163.com
  • 作者简介:杨晓伟(1994—),女,硕士研究生。主要从事固体废物资源化方面的研究。E-mali:1621538922@qq.com
  • 基金资助:
    山东省重大科技创新工程项目(2019JZZY020305,2018YFJH0902);山东省科学院国际科技合作项目(2019GHZD06)

Preparation and Properties Optimization of High StrengthCeramsite Obtained from Oily Sludge

YANG Xiaowei1, ZHANG Aisheng1, QU Junrong2, YANG Ke1, XU Jianhua1, ZHU Ying1   

  1. 1. Advanced Materials Institute,Qilu University of Technology (Shandong Academy of Sciences),Jinan 250014,China;
    2. The Company of Qingdao Loushanhe Water Resource,Qingdao 266000,China
  • Received:2020-08-15 Revised:2020-09-22 Online:2021-01-15 Published:2021-02-07

摘要: 为了解决危废油田污泥的堆存处置问题,研制了一种以油田污泥(简称油泥)为原料,以黄土、黄沙和黏土为添加剂的油泥烧结陶粒。通过单因素试验探究油泥最大掺量及最佳烧制工艺条件,并利用电子扫描电镜(SEM)、X射线衍射仪(XRD)和能谱仪(EDS)探究陶粒的显微结构、物相组成和内外层元素分布特征。结果表明,在油泥掺量为60%(质量分数),烧结温度为1 140 ℃,烧结时间为20 min时可以得到低吸水率、高抗压强度的目标陶粒。在最佳条件下,参照GB/T 17431.1—2010《轻集料及其试验标准》烧结的油泥陶粒1 h吸水率为0.32%,堆积密度为1 020.3 kg/m3,筒压强度为40.992 MPa。

关键词: 油田污泥, 高强陶粒, 危废, 资源化利用, 性能优化

Abstract: To solve the disposal problem of hazardous waste oily sludge,a high sludge doping sintered ceramsite which used oily sludge as raw material,loess,sand and clay as additives was prepared.The maximum content and the best conditions were tested by single factor experiment.The microstructure,phase composition and element distribution in the inner and outer layers of the ceramsite were investigated by scanning electron microscopy (SEM),X-ray diffraction (XRD) and energy dispersive spectroscopy (EDS).Results show that when the sludge content is 60% (mass fraction),the sintering temperature is 1 140 ℃,and the sintering time is 20 min,the target ceramsite with low water absorption and high compressive strength is obtained.Based on GB/T 17431.1—2010 "Light weight aggregate and its test methods",the ceramsite 1 h water absorption is 0.32%,the bulk density is 1 020.3 kg/m3 and the barrel pressure strength is 40.992 MPa under the best conditions.

Key words: oily sludge, high strength ceramsite, hazardous waste, resource utilization, property optimization

中图分类号: