欢迎访问《硅酸盐通报》官方网站,今天是

硅酸盐通报 ›› 2020, Vol. 39 ›› Issue (12): 3858-3865.

• 资源综合利用 • 上一篇    下一篇

玄武岩纤维原料特征分析

刘昶江1,2, 仝晓聪1, 刘忠1, 杨春成1,2, 李红超1,2, 姜乐涛1,2   

  1. 1.河北地质大学宝石与材料学院,玄武岩纤维材料研究所,石家庄 050031;
    2.河北地大宝谷孵化器有限公司,石家庄 050031
  • 发布日期:2021-02-01
  • 作者简介:刘昶江(1989—),男,博士,讲师。主要从事硅酸盐体系材料设计及应用研究。E-mail:liucj@cugb.edu.cn
  • 基金资助:
    院士工作站建设补助经费(204790416H);中央引导地方科技发展资金(206Z1501G)

Analysis of Basalt Fiber Raw Material Characteristics

LIU Changjiang1,2, TONG Xiaocong1, LIU Zhong1, YANG Chuncheng1,2, LI Hongchao1,2, JIANG Letao1,2   

  1. 1. Institute of Basalt Fiber Materials, School of Gemology and Materials Science, Hebei GEO University, Shijiazhuang 050031, China;
    2. Hebei GEO University Baogu Incubator Co., Ltd., Shijiazhuang 050031, China
  • Published:2021-02-01

摘要: 玄武岩纤维是以天然玄武岩为主要原料,经熔融和快速拉丝工艺制备而成的连续纤维材料,其性能受原料影响较大,且并非所有玄武岩均可直接制备玄武岩纤维。立足于玄武岩纤维原料的优选与标准化调配,以14个纤维及20个岩石样品的化学成分为基础,综合分析其化学组分、矿物组成、岩石性能、熔体结构与性质等特征。从氧化物组分类别及其摩尔比例、酸度系数、矿物组成、碱性岩种类、铝饱和程度、熔体解聚度与粘度关系等角度对可拉丝原料特征进行了归纳。结果表明,一般用于纤维生产的原料为氧化物组成摩尔分数范围RO2=0.58~0.75、R2O3=0.15~0.20、RO=0.18~0.30(R为阳离子),酸度系数为3.5~5.8,非晶或隐晶质的钙碱性、偏铝质岩石,其主要矿物为斜长石和单斜辉石,不含石英、橄榄石、刚玉等高熔点矿物,通常其熔体的解聚度NBO/T为0.2~0.4、粘度lgη为0.5~1.4 Pa·s。

关键词: 玄武岩纤维, 原料特征, 硅酸盐熔体

Abstract: Basalt fiber is a kind of continuous fiber material prepared by melting and followed fast drawing process from raw basalt ore, whose properties depend strongly on its raw materials, and not all of basalt is suitable for fiber production.The present work aims to provide useful information for the optimization and standardization of the raw materials for basalt fiber production. Based on the chemical composition of 14 fibers and 20 rocks, the characteristics of chemical components, mineralogy, lithology, melt properties and structure were analyzed comprehensively in this work. A series of limited conditions, including classes and molar fraction of the oxide components, acidity coefficient, mineral composition, types of alkaline rocks, saturation of alumina, relations between depolymerization degrees and viscosity of the melts were generalized. The result shows that the amorphous or cryptocrystalline, calc-alkaline, and metaluminous rock composed of plagioclase and clinopyroxene without quartz, olivine, corundum is suitable for fiber production. Moreover, oxides molar fraction and acidity coefficient of the raw rock are RO2=0.58 to 0.75, R2O3=0.15 to 0.20, RO=0.18 to 0.30 (R stands for cations), and 3.5 to 5.8, respectively. For the silicate melts, NBO/T is 0.2 to 0.4, and lgη is 0.5 Pa·s to 1.4 Pa·s, respectively.

Key words: basalt fiber, raw material characteristic, silicate melt

中图分类号: